By Just spraying through the air inlet, without disassembling the engine, it removes dirt caused by varnish or carbon from the combustion chamber or the carburetor, and restores its power while normally adjusting the engine.
Name of product | Engine Conditioner |
---|---|
JAN code | 4975759111023 |
Content | 300ml |
How to use the product
1. Leave the car idling for 5-6 minutes to warm the engine.
2. Stop the engine and loosen rubber hoses a bit to make enough space to insert the tube allowing you to spray toward the throttle chamber.
3. Turn on the engine and use a whole bottle while keeping the engine idling at about 2000 times engine rotation.
4. Meanwhile leave it for 5-6 minutes after the engine stops, and reset the rubber hose. Afterwards turn on the engine and snap until white smoke is not produced.
5. Perform this process as needed.
2. Stop the engine and loosen rubber hoses a bit to make enough space to insert the tube allowing you to spray toward the throttle chamber.
3. Turn on the engine and use a whole bottle while keeping the engine idling at about 2000 times engine rotation.
4. Meanwhile leave it for 5-6 minutes after the engine stops, and reset the rubber hose. Afterwards turn on the engine and snap until white smoke is not produced.
5. Perform this process as needed.