Apply this, and rain will bead up and roll down the glass, cleanly taking with it any other water along the way. Just by driving at 45 km/h or more, all the water will fly off the glass! No surface preparation work required! Glaco Q coats the glass at the same time as removing traffic film or a previous coating. Shaped like a computer mouse, this easy to grip applicator cuts down on the time required to renew your hydrophobic glass coating.
Name of product | Glaco Q |
---|---|
JAN code | 4975759041689 |
Content | 70ml |
Ingredients and materials | Silicones, acids, alcohols, cleaning agents |
Storage and disposal methods | STORE SEALED BELOW 40℃, OUT OF DIRECT SUNLIGHT. AVOID HUMIDITY, FREEZING, AND WETTING. USE/RELEASE CONTENTS COMPLETELY BEFORE DISPOSING ACCORDING TO LOCAL REGULATIONS. |
How to use the product
2. Use the felt applicator to rub the liquid firmly into the glass. Be sure to get complete coverage.
3. After drying for 5-10 minutes, wipe off the residue with a damp, wrung-out towel.
-
- FOR GLASS SURFACES ONLY.
IF THE PRODUCT COMES INTO CONTACT WITH ANYWHERE OTHER THAN THE DESIRED PLACE, WIPE OFF IMMEDIATELY WITH A CLEAN TOWEL TO PREVENT PAINT DAMAGE.
USE ONLY FOR INTENDED PURPOSE.
DO NOT OPEN OR USE TOWARDS THE FACE, EYES OR BODY. MAKE SURE PRODUCT DOES NOT TO COME INTO CONTACT WITH CLOTHING, IF THIS OCCURS WASH IMMEDIATELY.
DO NOT USE IN DIRECT SUNLIGHT OR ON HOT SURFACES. MAY CAUSE STREAKING.
AVOID APPLYING IN RAINY WEATHER OR WHEN THE TEMPERATURE IS LESS THAN 10°C, IF THIS IS THE CASE, APPLY WHILE WARMING THE GLASS WITH THE HEATER AND DEFOGGER.
WIPE OFF ALL MOISTURE BEFORE APPLYING TO GET THE FULL EFFECT.
IF TOO MUCH PRODUCT IS APPLIED, OR IF THERE IS AN OLD COATING ON THE GLASS, IT MAY CAUSE WATER MARKS.
WHEN USING FOR THE FIRST TIME, IF THE CAR IS ALREADY TREATED WITH A COATING OTHER THAN GLACO, THE FULL EFFECT MAY NOT BE ACHIEVED. IN THIS CASE, PLEASE BUY AN OIL-REMOVING OR COATING-REMOVING CLEANER. SOLD SEPARATELY.
DO NOT LEAVE PRODUCT ON FOR A LONG TIME AS IT WILL CAUSE UNEVENNESS AND STAINS.
IF FELT BECOMES DIRTY, REMOVE AND CLEAN THOROUGHLY AS DIRT MAY CAUSE SCRATCHES. ALLOW TO DRY COMPLETELY BEFORE USING AGAIN. IF THE FELT IS STILL WET, THE FULL EFFECT CANNOT BE ACHIEVED.
AFTER USE, COVER WITH TRANSPARENT COVER TO PREVENT EVAPORATION AND CONTAMINATION. REPLACE CAP TIGHTLY (ONE CLOCKWISE TURN.)
- FOR GLASS SURFACES ONLY.
-
DO NOT EAT OR DRINK. HARMFUL IF SWALLOWED OR INHALED.
AS SKIN IRRITATION MAY OCCUR, PLEASE WEAR PROTECTIVE GLOVES.
FLAMMABLE. KEEP AWAY FROM HEAT AND FIRE. BE CAREFUL. WHEN THERE ARE CHANGES IN TEMPERATURE/HUMIDITY, LIKE WHEN COMING OUT A TUNNEL, GLASS MAY TURN TEMPORARILY WHITE.
IN THIS CASE, USE THE WIPERS IMMEDIATELY TO REGAIN VISIBILITY. KEEP OUT OF REACH OF CHILDREN AND VULNERABLE PEOPLE.
Product Q&A
- Q
Can it be used on side mirrors?
- Q
Is there anything I should be aware of when I use it for the first time?
- Q
What should I do if I can't wipe it off?
- Q
How many windshields can I treat with one product?
- Q
What should I do with for daily maintenance?
- Q
What kind of window washer solution should I use?
- Q
Can I use it except on glass?
- Q
Can I use it even when the glass is wet?
- Q
How do I remove Glaco Q?
- Q
After use, there is some unevenness…
- Q
There is some glare that makes it difficult to see.
- Q
Could this damage rubber or plastic parts?
- Q
Can I use Glaco on helmet visors?