Plastic trim deteriorates over time due to exposure to UV and other contaminants. Plastic that has turned gray or lost its sheen is unsightly, and can be expensive to replace, but our two-step restoration kit brings back that fresh look to hard plastic parts, and protects them from further degradation. This kit includes two liquids: Liquid Binder to clean the surface of plastic parts, and Hard Clear Coat that coats them with a hard transparent layer, which protects them from the elements, and also restores a fresh-looking sheen.
| Name of product | BLACK PARTS ONE -Unpainted Resin Parts Refresh Kit- |
|---|---|
| JAN code | 4975759031345 |
| Content | Base Cleaner : 40ml Coating Liquid : 8ml Special sheet × 4 Special sponge × 4 |
| Ingredients and materials | Silicon compounds, alcohols |
| Storage and disposal methods | STORE SEALED BELOW 40℃, OUT OF DIRECT SUNLIGHT. AVOID HUMIDITY, FREEZING, AND WETTING. USE/RELEASE CONTENTS COMPLETELY BEFORE DISPOSING ACCORDING TO LOCAL REGULATIONS. |
How to use the product
1. First, wash and dry the parts to be treated.
2. Shake the bottle of Liquid Binder well, and apply to one side of the included cloth. Spread evenly over the surface of the plastic.
3. When finished, wipe off the Liquid Binder with the clean side of the cloth.
4. Separate a piece of the included sponge, and add a small amount of Hard Clear Coat to the black surface. Spread thinly and evenly over the plastic.
5. After about 5 minutes of drying, wipe with a fresh included cloth to smooth any unevenness.
Note: Do not touch or wet for 24 hours after application. Coating must be applied with the included sponge. Do not reuse sponges. Some precipitate solid may be present in the Liquid Binder, but this is not a problem. Shake well before use.
2. Shake the bottle of Liquid Binder well, and apply to one side of the included cloth. Spread evenly over the surface of the plastic.
3. When finished, wipe off the Liquid Binder with the clean side of the cloth.
4. Separate a piece of the included sponge, and add a small amount of Hard Clear Coat to the black surface. Spread thinly and evenly over the plastic.
5. After about 5 minutes of drying, wipe with a fresh included cloth to smooth any unevenness.
Note: Do not touch or wet for 24 hours after application. Coating must be applied with the included sponge. Do not reuse sponges. Some precipitate solid may be present in the Liquid Binder, but this is not a problem. Shake well before use.
-
- USE ONLY FOR INTENDED PURPOSE.
FLAMMABLE. KEEP AWAY FROM HEAT AND FIRE.
DO NOT GET WET DURING DRYING.
DO NOT OPEN OR USE TOWARDS THE FACE, EYES OR BODY. MAKE SURE PRODUCT DOES NOT TO COME INTO CONTACT WITH CLOTHING, IF THIS OCCURS WASH IMMEDIATELY.
DO NOT USE IN HOT, RAINY OR COLD WEATHER LESS THAN 10°C DEGREES. MAY CAUSE IRREGULARITIES.
WHITENING MAY OCCUR WHERE THERE IS STRONG FRICTION.
LIQUID REACTS WITH AIR, CLOSE CAP IMMEDIATELY AFTER USE. STORE IN A COOL PLACE AWAY FROM SUNLIGHT.
WASH HANDS WELL WITH SOAP AFTER USE.
- USE ONLY FOR INTENDED PURPOSE.
-
DO NOT EAT OR DRINK. HARMFUL IF SWALLOWED OR INHALED.
AS SKIN IRRITATION MAY OCCUR, PLEASE WEAR PROTECTIVE GLOVES.
FLAMMABLE. KEEP AWAY FROM HEAT AND FIRE.
KEEP OUT OF REACH OF CHILDREN AND VULNERABLE PEOPLE.